Instructions

About

1. Open your box. 2. Place pot on a table with temperature gage towards left hand side. 3. Take the smallest piece of the thumper with drain plug facing towards you and put to the right of the pot. 4. Take the worm which is attached to coil and put to the right of the thumper. 5. Take the cap and insert it to the top of the pot, the bottom of the cap connects by spinning the spin ttings to the left side of the thumper. A) The seam on the top of cap should interlock with seam of the back of the pot. 6. When connecting the spin fitting, if they should leak, use thread locking tape or wheat paste. The unit also comes with an adapter piece which is copper, and it connects to the top of right hand side of the thumper and goes to the worm spin fittings accordingly. . 7. Congratulations! You have successfully assembled your Moonshine Still but you still need to know how to use it. 8. You need a burner or any source of flame, you could also have a submerged heating element. Once you have a burner and propane you need some MASH. Mash is what you put in the still to get liquor. 9. MASH= Fermented materials that can range anywhere between 1% to 35% ABV (Alcohol By Volume). The higher the ABV, the more alcohol you will be able to pull out. The goal is to take out as much alcohol out of the mash with your Moonshine Still. VISIT: WWW.MASH.RECIPES FOR SOME EASY RECIPES TO GET STARTED. You are going to need a Hydrometer, which measures the alcohol content of the Mash, ‘cause it’s always nice to know what your alcohol is in the beginning and the end of the process. There are two different types of Hydrometers, one to use for low proof (of Mash) and one for high proof. Visit our accessory page to purchase more items from us. 10. Strain Mash for any hard materials and pour into pot. You are going to need to seal the cap of the pot with “old school” Wheat Paste or Black Electrical Tape, make sure to seal the unit well. The thumper is a double purification unit, it is not a necessity. W

On-page SEO