Motor Mount

About

Stick It Anchor Pins Motor Mount Bracket The Stick It Anchor Pins Motor Mount Bracket is a ⅜” thick aluminum mounting bracket that attaches where your motor meets the transom. It mounts directly on top of your outboard motor’s mounting bracket. It’s recommended for flats boats/bass boats up to 20ft and bay boats up to 19ft and with 200hp engines or less. Motor Mount will fit engine bolt spacing of 7-¼” to 8-¾” inches apart. Be sure to check for clearance of trim tabs, trailer tie downs, eye cleats, poling platforms, or any other object mounted near your transom wall. It can be used with some jack plates, but when moving the jack plate, clearance can be an issue. The complete Motor Mount system includes: Aluminum motor mount bracket in black or white 7-, 8-, or either the 10-foot or 12.5-foot without the screw fitting . Anchor Pin in black or white Neoprene impact cushion - protects handle from boat rocking Pin positioning grommet - positions pin ready for deployment ¾” mounting clips - convenient way to store pin on your boat Rough water safety straps for mounting clips for extra security Comprehensive instructions. Installation is easy. Loosen the upper motor mount nut and place Stick It Motor Mount onto it. Hand tighten that nut. Then loosen the lower nut and slip the Motor Mount hole over that bolt. Then, tighten both nuts. It’s just that easy.

On-page SEO