Siser Vernice Heat Transfer Vinyl

About

Vernice Heat Transfer Vinyl Introducing the Ultra-Glossy Vernice HTV! Looking for something sleek rather than subtle? Dial the gloss factor up to 11 with Siser®’s Vernice HTV! Vernice is an ultra-glossy HTV that gives designs an incredibly polished appearance. It’s just as thin as EasyWeed® too, so you can add sheen to your garments while keeping them lightweight. Vernice can also be applied as a top layer on other layerable materials, like EasyWeed, Sparkle™, and StripFlock® Pro. Vernice is CPSIA Certified so it's perfect for decorating children's clothing and accessories. Specifications: PU composition • Pressure sensitive backing • Ultra-gloss finish • 90 Microns/3.54 Mils • 45°/60° blade • Top Layer Only CUTTER SETTINGS Siser Romeo & Juliet: Blade: 45°/60° Gram Force: 5-10 Offset: .250 Speed: 10 Cricut Explore Air: Blade: Standard Setting: Iron-On Silhouette Cameo: Blade: Standard, 3 Setting: Heat Transfer, Smooth Speed: 8 Force: 6 Scan N Cut: Blade: Standard, 2 Cut Speed: 5 Cut Pressure: 1 Roland GS/GX-24: Blade: 45° Gram Force: 80-90 Offset: .250 Speed: 30-50 cm/s Graphtec: Blade: 45° Gram Force: 8-9 Tool: CB09U+0 Speed: 30 cm/s MH, SC2, LP3, Titan 1: Blade: 45°/60° Gram Force: 80-85 Speed: 300 mm/s *Blade Advancing Varies Titan 2 & 3 Blade: 45°/60° Gram Force: 60-65 Speed: 300mm/s *Blade Advancing Varies Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs. APPLICATION INSTRUCTIONS Application Instructions (home iron) • Set iron dial between Cotton and Linen • Cover design with Kraft paper or non-stick cover sheet • Place on flat, hard surface (ironing board not recommended) • Press iron with medium/firm pressure (do not slide iron) • Press each section of design for 10-15 seconds • If areas of design lift after application, replace cover sheet and re-press for 10 seconds • Peel carrier hot or cold Application Instructions (heat press) • Cut in Reverse • Weed excess material • Preheat garmen